Settings & Launch

The Scroll module's modes. How to configure and launch them.

Settings & Launch is the main tab of the Scroll module. It allows you to select the mode you need, select wallets, configure the selected mode and run the module

Starting modes

• Bridge Mode - for interacting with bridges;

• Block Mode - for interacting with the main protocols on the Scroll network.

Module operation mode selection.

Launch options

The Run mode section allows you to select the execution sequence for your wallets (applicable for both the Block Mode and the Bridge Mode).

Right now, you can choose one of 3 options:

• Parallel - your wallets launching an operation in parallel (multithread), with or without IPv4 proxies;

• Оne-by-one - your wallets launching operation sequentially, one after another, with or without IPv4 proxies;

• Оne-by-one (mobile proxy) - your wallets launching operation sequentially using SPECIFICALLY mobile proxies. The proxies have to be added through Settings -> Proxies beforehand.

Selecting a run mode in the Scroll module.

Selecting wallets to launch

• Select the wallets you wish to use in this session in the "Select wallets to launch" section.

Selecting wallets.

• To launch a preconfigured group of wallets, you just need to select it in the "Select Accounts group to launch". Grouping wallets is done in Account manager -> Grouping wallets.

Selecting an account group to be launched.

Now let's dive into more detail on how to configure each of the two main module modes:

• Bridge Mode

• Block Mode