Set up and run sessions to interact with the NFTs2me protocol.

This mode gives you the ability to minecraft NFTs created on the NFTs2me site by simply inserting a collection contract.

Setting up and starting a session:

  • In the Mode section, select Block Mode;

  • In the Run mode section, choose the order in which wallets will launch:

    1. Parallel - parallel operation (multi-threaded) with or without proxies;

    2. One-by-one - wallets will launch one after the other with or without proxies;

    3. One-by-one (mobile proxy) - wallets will launch one after the other using mobile proxies. Mobile proxies must be added in Settings -> Proxies and linked to accounts in the Account Manager in advance;

  • To use a ready-made preset of software settings, click on the selection field in the Select preset section and choose the desired preset;

  • To launch a pre-prepared group of wallets, select the desired group in the Select Accounts group to launch section;

  • To add a collection contract address, click Add or Edit Contracts;

  • Paste the contract address you copied from the explorer into the Contract address field;

  • Click Add To List to add this contract to the Contract list. This is essentially your "basket," where all added contracts are stored for wallets to interact with during the session;

  • If you want to delete one of the contracts, click the trash icon. If you want to clear the entire list, click Delete All.

  • In the Delays section, set delays between actions:

    1. Wallet - delay between wallet launches;

    2. Block - delay between mints on one wallet;

  • By clicking on Pro, you will open the Gas guard setting. If this delay is activated, your wallet will additionally go to sleep if several accounts in the same session are simultaneously ready to work after reaching the gas level you set for the software. We did this so that all these wallets do not start sending transactions at the same time after reaching your specified gas level. The standard delay is set in the range of 30 to 150 seconds;

  • In the Max gas price section, set the maximum gas in the Scroll network at which transactions will be made. The software will wait until the gas in the Scroll network drops to the desired value and only then start making transactions. After launching the session, it is possible to change the upper Gwei level in the Logs & Progress tab by going to the Sessions section;

  • In the Mint count range field, enter the range of the number of NFTs to be minted on each wallet;

  • If you want the wallets to start working in random order, leave the Randomize wallets checkbox checked;

  • Enable the Allow duplicate minting of the same NFT on the same wallet checkbox to allow the script to repeatedly mint the same NFTs to achieve the number of transactions you specified in the Mint count range section. If it is not enabled, the software will not mint duplicate NFTs on wallets and will skip duplicates, moving on to collections that are not yet on a specific wallet;

  • To save the session delay settings for use in other sessions, click the Save this as preset button, enter the preset name, and save. Later, this preset can be selected in the Select preset field;

  • Click Update Balances to get the current ETH balances on wallets;

  • Select the wallets you want to launch, and click Launch.

  • Your wallets have been launched. You can track the process of work of your wallets in the section Logs & Progress.

Obtaining the NFT contract address:

  • Go to the collection on the NFTs2me website;

  • Click on the explorer icon to go to the explorer;

  • Copy the collection address;

  • Paste this address into Combine.

Last updated