Merkly NFT Mint & Bridge
Set up and put into operation wallets for minting and sending NFTs via the Merkly protocol.
The Merkly NFT Mint & Bridge mode allows you to mint and send NFTs to other networks via the Merkly protocol.
NFTs are minted on the Scroll network with the ability to send the minted NFT to any of the 20 available networks.
Setting up and starting a session:
In the Mode section, select Block Mode;
In the Run mode section, choose the order in which wallets will be launched:
Parallel - parallel operation (multi-threaded) with or without proxies;
One-by-one - wallets will be launched one after another with or without proxies;
One-by-one (mobile proxy) - wallets will be launched one after another using mobile proxies. Mobile proxies must first be added in the Settings -> Proxies section and linked to accounts in the Account Manager;
To use a preset software operation settings, click the selection field in the Select preset section and choose the desired preset;
To launch a pre-prepared group of wallets, select the necessary group in the Select Accounts group to launch section;
In the Bridge NFT After Mint to field, choose the network to which the NFT will be sent after minting;
In the Delays section, set the delay between wallets in the Wallet field;
When you click Pro, the Gas guard setting will open. When this delay is activated, your wallet will go to sleep if several accounts in the same session are ready to work simultaneously after reaching the gas level you set for the software. We did this to prevent all these wallets from sending transactions simultaneously after reaching your set gas level. The standard delay is set in the range of 30 to 150 seconds;
In the Max gas price section, set the maximum gas price in the Scroll network at which transactions will be made. The software will wait for the gas price in the Scroll network to drop to the required level and will only then start making transactions. After starting the session, it is possible to change the upper Gwei level in the Logs & Progress tab by going to the Sessions section;
If you want wallets to start working in a random order, leave the Randomize wallets checkbox enabled;
To save the session delay settings for use in other sessions, click Save this as preset, enter the preset name, and save. Later, this preset can be selected in the Select preset field;
Click Update Balances to get the actual ETH balances on the wallets;
Select the wallets you want to launch, and click Launch.
Your wallets have been launched. You can track the process of work of your wallets in the section Logs & Progress.
Last updated
