Merkly NFT Mint & Bridge
Set up and put into operation wallets for minting and sending NFTs via the Merkly protocol.
The Merkly NFT Mint & Bridge mode allows you to mint and send NFTs to other networks via the Merkly protocol.
NFT minting is done on the Base network, with the ability to send the minted NFT to any of the 20 available networks.
Setting up and starting a session:
In the Mode section, select Block Mode;
In the Run mode section, choose the order in which wallets will be launched:
Parallel - parallel operation (multi-threading) with or without proxies;
One-by-one - wallets will be launched one after another with or without proxies;
One-by-one (mobile proxy) - wallets will be launched one after another using mobile proxies. Mobile proxies must first be added in the Settings -> Proxies section and linked to accounts in the Account Manager.
To use a ready-made software settings preset, click on the selection field in the Select preset section and choose the desired preset.
To launch a pre-prepared group of wallets, select the desired one in the Select Accounts group to launch section;
In the Bridge NFT After Mint to field, choose the network to which the NFT will be sent after minting;
In the Delays section, set the delay between wallets in the Wallet field;
When you click on Pro, the Gas guard setting will open. If this delay is activated, your wallet will additionally go to sleep if several accounts in the same session are ready to work simultaneously after reaching the gas level you set for the software. We did this so that all these wallets do not start sending transactions simultaneously after reaching your specified gas level. The standard delay is set in the range of 30 to 150 seconds;
In the Max gas price section, set the maximum gas in the Base network at which transactions will be made. The software will wait for the gas in the Base network to drop to the desired level and then start making transactions. After starting the session, you can change the upper Gwei level in the Logs & Progress tab by going to the Sessionssubsection;
If you want wallets to be activated in random order, leave the Randomize wallets checkbox enabled;
To save the session delay settings for use in other sessions, click the Save this as preset button, enter the preset name, and save it. Later, this preset can be selected in the Select preset field;
Click Update Balances to get the current ETH balances on the wallets;
Select the wallets you want to launch and click Launch.
Your wallets have been launched. You can track the process of work of your wallets in the section Logs & Progress.
Last updated
