Bridge mode Starknet

How to bridge tokens through Bridge mode in the Starknet module.

• Select "Bridge mode" in the "Mode" section.

• Select one of the three run mode options in "Run Mode".

• Next, select the bridge you want to interact with in the "Bridge type" section. The two available options are the Starknet official bridge and Orbiter.

Selecting a bridge.

• In the "Account delays" section, set the delay in seconds between account launches.

Delay between account launches.

• If the bridge selected in the "Bridge type" section is the Starknet official bridge, then you can select depositing from Ethereum or withdrawing from Starknet to Ethereum in the "Bridge mode" section.

Selecting the bridging direction.

• The "Amount" section has two subsections: "Send range" and "Leave range"

"Send range" lets you send a specified $ETH range, whereas "Leave range" lets you leave a specified $ETH range on wallets and only send whatever is above this threshold.

Selecting the bridging mode.

• Enter the ranges and click "Apply to selected wallets". The actual amount to be applied to a wallet will be visible in the "Amount to bridge" field. You can configure this field manually.

Selecting the amount of $ETH for bridging.

• Next, set the gas limit on Ethereum for the transactions. The app will wait until the gas price falls to the set limit.

Setting a gas limit for transactions.

• If you want to randomize the order in which your wallets launch, tick the "Randomize wallets?" checkbox.

• To start the software click "Launch".

Configuring and launching the Starknet module.

• Done. Now you can read logs for this launch in Logs & Progress.