Bridge mode Linea
How to bridge tokens through Bridge mode in the Linea module.
Select "Bridge mode" in the "Mode" section.
Select one of the three run mode options in "Run Mode".
Next, select the bridge you want to interact with in the "Bridge type" section. The three available options are the Linea official bridge, Orbiter, and Stargate.
In the "Account delays" section, set the delay in seconds between account launches.
If the bridge selected in the "Bridge type" section is the Linea official bridge, then you can select depositing from Ethereum or withdrawing from Linea to Ethereum in the "Bridge mode" section.
If the Bridge selected in the "Bridge type" section is Orbiter, you may transfer tokens from Arbitrum, Polygon, Optimism, BNB, and Ethereum to Linea and back. Select the transfer origin network for your tokens in the first field.
Select the destination network for your tokens in the second field.
The Stargate bridge follows the same configuration principles as Orbiter.
The "Amount" section has two functions: "Send range" and "Leave range".
"Send range" lets you send a specified $ETH range, whereas "Leave range" lets you leave a specified $ETH range on wallets and only send whatever is above this threshold.
Enter the ranges and click "Apply to selected wallets". The actual amount to be applied to a wallet will be visible in the "Amount to bridge" field. You can configure this field manually.
Next, set the gas limit on Ethereum for the transactions. The software will wait until the gas price falls to the set limit.
If you want to randomize the order in which your wallets launch, tick the "Randomize wallets?" checkbox.
To initiate a session, click "Launch".
Done. Now you can read logs for this launch in "Logs & Progress".
Last updated
